DESCRIPTION
AquaGard 7100 is a high performance single component primer and intermediate coat that uses potable water for thinning and clean-up. AquaGard 7100 is ideal for use in severe marine environment where maximum safety and elimination of hazardous waste is desired. It contains no lead or chromium pigments, has a low V.O.C. content and is non-combustible with no lower explosive limit. Available in red, black, and yellow oxide.
FIELD OF APPLICATION
AquaGard 7100 provides a level of protection better than traditional zinc and epoxy systems. It is ideal for use as an environmentally friendly primer and intermediate build coat on offshore structures, drilling rigs, ships, supply boats, barges, storage tanks and pipelines. It is particularly useful for application in engine rooms that are operating or in shipyards where simultaneous welding and painting must take place.
SERVICE CONDITIONS
AquaGard 7100 will withstand 140oF (60oF) continuous dry heat. Do not apply to damp surfaces. Do not use where the dried film will be exposed to strong solvents or extreme abrasion. May be applied over aluminum with special application procedure.
DESCRIPTION
AquaGard 8000 is a single component acrylic finish coat that uses potable water for thinning and clean up. It contains no lead or chromium pigments, has a low V.O.C. content and is non-combustible with no lower explosive limit. AquaGard 8000 is a user friendly product that does not contribute to hazardous waste disposal problems. It is available in a wide color selection.
FIELD OF APPLICATION
AquaGard 8000 is ideal for use as an environmentally friendly finish coat where long term flexibility, gloss and color retention are required. It may be applied over AquaGard 7100 waterborne Vinyl, UltraGard 201 All season Epoxy or used as a refresher finish coat over intact solvent based and waterborne coating systems after all surface contamination has been removed. AquaGard 8000 is an excellent choice for a finish coat on ships and crew boats above the deep load line, offshore structures above the splash zone, storage tanks and many other locations where a urethane coating would normally be specified.
SERVICE CONDITIONS
AquaGard 8000 will withstand continuous dry heat of 200oF. Do not apply to damp surfaces or put into immersion service. The color may change as these limits are approached, but the film will remain intact. AquaGard 8000 is highly resistant to light industrial fumes and chemicals.